Skip to content

Getting started#

Start using the Interoperability tests feature right away. This short instruction will help you create your first test case, run it on a device and see the execution logs.


  • A device that is added and registered in the platform.

Create your first test case#

  1. From the navigation menu on the left, select Protocol tests configuration. Protocol tests tab
  2. Click the Add a new test case button in the top-right corner. Adding a new test case Configure your test case:
    • Provide a name for your test case.
    • Under the Action list, click the Add action button and select Write from the drop down list and provide data for the following fields:
      • Parameter name: Device.0.Manufacturer,
      • Expected value: Example_manufacturer,
      • Expected response code: 4.05 MethodNotAllowed.
    • Under the Action list, select Read from the drop down list and provide data for the following fields:
      • Parameter name: LwM2M Server.1.Binding,
      • Expected value: U,
      • Expected response code: 2.05 Content.
    • Select the Add a new test case button.

Run the test case on device#

  1. In the Device inventory, select a currently registered device and enter its Device Management Center.
  2. In Device Management Center, select the Protocol tests tab.


    If the Protocol tests tab is not visible in the menu, use the settings button under the menu to add it: drag it from Available tabs and drop it in Selected tabs and click Confirm.

  3. Tick the test case you have just created and click Run selected (1). Running a test case

  4. After a few moments, the execution should end and test case status changes from In progress to Success.


The Success status of a test case is a measure of the correctness of the device response against the expected test case parameters. Depending on the device and tester's needs, there may be test cases that are successful when the device responds with a Failure message (similarly to the example presented in this section).

Check test execution details#

To see test execution logs for your test case:

  1. While in the Protocol tests panel, find your test case and click on its name.
  2. Expand the Logs section using the ^ arrow icon to see execution details.

Checking test case results 3. Use the Check logs button for each action inside the test case to see the highlighted results for this action.

Last update: June 15, 2021